Installation Instructions

FormNo.3377-930RevB

AirHammerAdapterKit

4045or4050DirectionalDrill

ModelNo.23832

ModelNo.23832E

InstallationInstructions

InstallingtheAdapter

1.Removeanddiscardtheinletwaterhosefrom

themudpump(Figure1).

2.Removethesprayhosettingfromtheteetting

mountedtothemachinebracket.Donotdiscard

thettings(Figure1).

g023222

Figure1

1.Inletwaterhose3.Existingspray-hose

hardware

2.Machinebracket4.Drillstemhoseandball

valve

3.Assembletheadapterpartswithpipeputtyor

pipe-sealanttapeandinstallittothemachine

bracketasfollows:

Note:Fittingssealedwitho-ringsdonotrequire

pipeputtyorpipe-sealanttape.

A.Installthestraighttting,ballvalve,and

straightttingwithswiveltothehoseand

existinghardware(Figure2).

B.Installtheexistingballvalveandhardware

asshowninFigure2.

C.Installthestraightttingwithswivel,pipe

coupling,pipenipples,ballvalve,and45

degreeelbowtotheteetting(Figure2).

D.Installthelarge-pipenipple,bellreducer,

ttingreducer,andpipenippletothe45

degreeelbow(Figure2).

E.Assemblethesub-assembliestothe

machine.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3377-930*B

PAGE 1
Form No. 3377-930 Rev B Air Hammer Adapter Kit 4045 or 4050 Directional Drill Model No. 23832 Model No. 23832E Installation Instructions Installing the Adapter 1. 2. Remove and discard the inlet water hose from the mud pump (Figure 1). Remove the spray hose fitting from the tee fitting mounted to the machine bracket. Do not discard the fittings (Figure 1). C. Install the straight fitting with swivel, pipe coupling, pipe nipples, ball valve, and 45 degree elbow to the tee fitting (Figure 2). D.
PAGE 2
Installing the Wire Harness 1. Plug the wire harness into the connector near the pump inlet (Figure 3). 2. Plug the opposite end of the wire harness to the air hammer. g023151 Figure 3 1. Pump inlet g023223 Figure 2 1. Hose 10. Pipe coupling 2. Straight fitting 11. Pipe nipple 3. Ball valve 4. Straight fitting with swivel 12. Ball valve 13. 45 degree elbow 5. Existing hardware and ball valve 6. Machine bracket 7. Existing spray-hose hardware 8. Tee fitting 14. Fitting reducer 15.