Form No. 3420-325 Rev B Transport Light Kit 2226 Directional Drill Model No. 23902 Model No. 23902E Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Parts List 2x 1x 1x 2x 2x 4x © 2018—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 30x 1x 1x 1x Register at www.Toro.com.
Installing the Light Assemblies 1. Move the machine to a level surface, place the machine in TRAMMING MODE, shut off the engine, turn the battery disconnect switch to the OFF position, and remove the key; refer to the Operator’s Manual. 2. Install 1 of the light assemblies to the front bracket and tilt it 15 degrees toward the ground. 3. Torque the bolt to 1978 to 2542 N∙cm (175 to 225 in-lb).
4. Install the brackets and other light assembly. 5. Tilt the light assembly 7 to 17 degrees down for the best visibility. 6. Torque the bolt to 1978 to 2542 N∙cm (175 to 225 in-lb).
Routing the Wire Harness 1. Route the wire harness along the main harness and secure it using cable ties using caution not to route the harness near moving parts. 2. Plug the wire harness into the light assemblies.
g246520 Figure 6 1.
g235023 g235022 6
3. Connect the kit wire harness to the connector labeled LIGHT KIT CONNECTOR on the main wire harness. g246657 Installing the Fuse and Switch 1. Install the fuse and switch as shown. 2. Plug the switch into the wire harness.
Operation Open the rear control panel and push the switch to activate the lights.
