Installation Instructions

ManualsBrandsToro ManualsUtility VehicleToro 25419E

FormNo.3386-754RevB

22inReelCarrier

ProSneak360and365VibratoryPlow

ModelNo.25419

ModelNo.25419E

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Reel-carrierarms2

Reel-carrierpipe1

Stopcollar

Setscrew(3/8inch)

Clevispin

Cotterpin

Installthereelcarrier.

ROPS-cable-guidebracket

U-bolt(4inches)

Locknut(3/8inch)

Spacers

Hood-cable-guidebracket(model25400

only)

Nut(5/16)(model25400only)

Bolt(5/16x3/4inch)(model25400only)

Benthood-cable-guidebracket(model

25403only)

Bolt(5/16x1inch)(model25403only)

Installthecableguides.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3386-754*B

Summary of content (4 pages)

PAGE 1
Form No. 3386-754 Rev B 22in Reel Carrier Pro Sneak 360 and 365 Vibratory Plow Model No. 25419 Model No. 25419E Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 © 2014—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 Description Qty.
PAGE 2
1 Installing the Reel Carrier Parts needed for this procedure: 2 Reel-carrier arms 1 Reel-carrier pipe 1. Clevis pin 4. Reel carrier pipe 4 Stop collar 2. Cotter pin 5. Stop Collar 4 Set screw (3/8 inch) 3. Set screw (3/8 inch) 4 Clevis pin 4 Cotter pin Figure 2 3. Install the 2 outside stop collars on the reel-carrier pipe, and secure the stop collars with 4 set screws (3/8 inch) as shown in Figure 2. 1.
PAGE 3
Installing the Cable Guides for the ProSneak 365 1 1. Open the right or left side panels of the machine hood. 2. Remove the existing bolts and nuts between the front nose cone and the center strip. 2 Note: Do not discard the nuts. 3. Secure the bent cable-guide bracket between the center strip and the front nose cone using 2 bolts (5/16 x 1 inch) and the 2 nuts previously removed (Figure 5). 3 3 2 1 g022154 Figure 3 1. Bolt (5/16 x 3/4 inch) 3. Nut (5/16 inch) 2. Hood-cable-guide bracket 3.
PAGE 4
Making a Service Connection Operation 1. Dig a hole to the depth the cable is being laid and no wider than 0.6 m (2 ft). Important: Determine the location of underground lines before starting. 2. As you pass over the hole with the machine, stop the plow vibration and insert the plow-swing lock (Figure 7). Using the Reel Carrier 1. Remove the chute gate and insert the cable or tubing. 2. Install the chute gate. 1 Note: Check the chute links for wear and freedom of movement. 3.