Installation Instructions

ManualsBrandsToro ManualsUtility VehicleToro 25424

FormNo.3397-456RevA

23inand26inDualTireKit

ProSneak360and365VibratoryPlow

ModelNo.25423

ModelNo.25423E

ModelNo.25424

ModelNo.25424E

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Wheelassembly4

Adaptorplate4

Bolt4

Lugnuts20

Installthedualwheels.

WARNING

CALIFORNIA

Proposition65Warning

Thisproductcontainsachemicalorchemicals

knowntotheStateofCaliforniatocausecancer,

birthdefects,orreproductiveharm.

InstallingtheDualWheels

1.Parkthemachineonalevelsurfaceandstoptheengine.

2.Raiseonesideofthemachinesothattheweightisoff

thewheels;supportthemachinewithjackstands.

WARNING

Mechanicalorhydraulicjacksmayfailto

supportmachineandcauseaseriousinjury.

•Usejackstandswhensupportingmachine.

•Donotusehydraulicjackstosupportthe

machine.

3.Removethelugnutsfromoneofthewheels(BoxA

ofFigure1).

4.Rotatethewheelsintothenarrowconguration,if

theyarenotalreadysocongured(BoxBofFigure1).

RefertoRotatingtheWheelsintheOperator’sManualof

yourProSneakmachine.

Figure1

5.Installanadaptorplateontothewheelhubandsecure

itwiththelugnuts(BoxCofFigure1).

Note:Donottightenthenutsaroundthewheelina

clockwiseorcounterclockwiseorder.Instead,tighten

theminastarpattern,proceedingtothenutacrossthe

wheelfacefromthe1justtightened.

6.Torquethelugnutsto108to135N-m(80to100ft-lb).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3397-456*A

Summary of content (2 pages)

PAGE 1
Form No. 3397-456 Rev A 23in and 26in Dual Tire Kit Pro Sneak 360 and 365 Vibratory Plow Model No. 25423 Model No. 25423E Model No. 25424 Model No. 25424E Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. Wheel assembly Adaptor plate Bolt Lug nuts 4 4 4 20 Install the dual wheels.
PAGE 2
7. Align the tabs on the dual wheel with the slots in the adaptor plate (Box A of Figure 2). Figure 2 8. Install the dual wheel to the adaptor plate using a large bolt with thread-locking adhesive (Box B of Figure 2). Torque the bolt to 610 to 623 N-m (450 to 460 ft-lb). Note: Ensure that the tread on the dual wheel is pointing in the same direction as the other wheel. 9. Repeat this procedure for the rest of the wheels. 10.