Installation Instructions

ManualsBrandsToro ManualsTrenchersToro 25436

FormNo.3377-962RevA

48inHeavy-DutyCrumber

60inHeavy-DutyCrumber

RT600Trencher

ModelNo.25435

ModelNo.25436

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Crumberbar

Crumberblade

Hex-headbolt(M12x110mm)

Locknut(M12)

Carriagebolt(1/2x4inch)

Washer(1/2inch)

Locknut(1/2inch)

Installthecrumber.

Note:Youshouldhaveeither2peopleorliftingequipment

toperformthisprocedure.

1.Parkthemachineonarm,levelsurface.

2.Movetheboomtothehorizontalposition.

3.Turnofftheengineandremovethekey.

4.Ifthespacebetweenthemountingplatesistoonarrow

toinsertthecrumberbarbetweenthem,loosenthe

3boltsandthe3locknutsthatsecurethecrumber

mountingbracketstotheboomenoughsothatyoucan

insertthecrumberbarbetweenthem(

Figure1).

G02351 1

Figure1

1.Crumbermountingbracket

(2)

2.Locknuts

5.Looselyinstallthe4hex-headbolts(M12x110mm)

andthe4locknuts(M12)fromthekitontotheplates,

andinsertthecrumberbarbetweentheplatesandthe

boltsasshownin

Figure2.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3377-962*A

Summary of content (2 pages)

PAGE 1
Form No. 3377-962 Rev A 48in Heavy-Duty Crumber 60in Heavy-Duty Crumber RT600 Trencher Model No. 25435 Model No. 25436 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. 1 1 4 4 2 2 2 Crumber bar Crumber blade Hex-head bolt (M12 x 110 mm) Locknut (M12) Carriage bolt (1/2 x 4 inch) Washer (1/2 inch) Locknut (1/2 inch) Install the crumber.
PAGE 2
Note: Torque the bolts and locknuts to 124 to 154 N-m (91 to 113 ft-lb). 2 3 1 4 G023379 Figure 2 1. Locknut—M12 (4) 3. Mounting plates 2. Crumber bar 4. Hex-head bolt (4) 6. If you loosened the 3 bolts and the 3 locknuts that secure the crumber mounting brackets to the machine, torque them to 217 to 271 N-m (160 to 200 ft-lb). 7. Install the crumber blade onto the crumber bar with 2 carriage bolts (1/2 x 4 inch), a plate, 2 washers (1/2 inch), and 2 locknuts (1/2 inch) as shown in Figure 3.