Installation Instructions

FormNo.3383-980RevA

Auto-TiltChassis

RT1200TractionUnit

ModelNo.25511

ModelNo.25511E

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Tiltsensor1

Bolt2

Locknut2

Rockerswitch1

Installtheauto-tiltchassis.

Nopartsrequired

–

Calibratethesensor.

InstallingtheAuto-tiltChassis

1.Removethefourboltssecuringthefootplatetothe

frameandremovetheplate(Figure1).

Figure1

1.Footplate

2.Disconnectthewireharnessfromthefoot-pedal

sensorandsettheoorplateaside.

3.Installthetiltsensorundertheoorundertheseat

using2boltsandlocknuts(Figure2).

Figure2

1.Tiltsensor2.Bolts

4.Connectthesensortotheopenconnectorfromthe

mainwireharnessasshownin

Figure3.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3383-980*A

PAGE 1
Form No. 3383-980 Rev A Auto-Tilt Chassis RT1200 Traction Unit Model No. 25511 Model No. 25511E Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. Tilt sensor Bolt Locknut Rocker switch 1 2 2 1 Install the auto-tilt chassis.
PAGE 2
Figure 3 (Floor removed for illustrative purposes) 1. Tilt sensor 2. Wiring-harness connector 5. Connect the wire harness you disconnected in step 2 to the foot-pedal sensor. Figure 5 Home Screen 6. Install the foot plate, securing it with the 4 bolts removed previously, and connect the foot pedal to the drive linkage. 1. Up and down arrow keys 7. Remove the plug from the second switch position from the right on the control panel behind the seat (Figure 4). The diagnostic screen (Figure 6) displays.
PAGE 3
8. Use the toggle switch to return the machine to the level position. 9. Press button 2 to select Set Center (Figure 8) and wait unit the center indicator light turns green (approximately 10 seconds). 10. Use the toggle switch to tilt the machine to the full right position. 11. Press and hold button 3 to select Set Right (Figure 8) and wait unit the right indicator light turns green (approximately 10 seconds). 12. Return the machine to the level position. 13.
PAGE 4