Installation Instructions

ManualsBrandsToro ManualsTrenchersToro 25515

FormNo.3397-690RevA

DualFunctionAuxiliaryHydraulicsKit

RT1200TractionUnit

ModelNo.25515

ModelNo.25515E

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Valve-mountplate1

Solenoidvalve

Flatwasher3

Hex-headbolt3

Hexplug4

Smallstraighttting

Largestraighttting

Hex-head-angebolt

Installthekit.

InstallingtheKit

1.Movethemachinetoalevelsurfaceandengagethe

parkingbrake.

2.Shutofftheengine,waitforallmovingpartstostop,

andremovethekeyfromtheswitch.

3.Installthesmallstraightttingandthe2largestraight

ttingsontothesolenoidvalveasshowninFigure1.

Note:TheO-ringsmayalreadybeinstalledonthe

ttings.

g032007

Figure1

1.Solenoidvalve4.SmallO-ring

2.LargeO-ring(2)5.Smallstraighttting

3.Largestraighttting(2)

4.Torquethesmallstraightttingto15to20N∙m(11

to15ft-lb)andthe2largestraightttingsto47to58

N∙m(35to43ft-lb).

5.Installthesolenoidvalveandattachedttingsonto

thevalve-mountplatewith3hex-headboltsand3at

washers(Figure2).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3397-690*A

Summary of content (4 pages)

PAGE 1
Form No. 3397-690 Rev A Dual Function Auxiliary Hydraulics Kit RT1200 Traction Unit Model No. 25515 Model No. 25515E Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Note: Determine the left and right sides of the machine from the normal operating position. Loose Parts Use the chart below to verify that all parts have been shipped.
PAGE 2
7. Install the valve-mount plate (with the attached solenoid valve and fittings) onto the rear of the machine with the bolts that you previously removed in step 6. 8. Locate the hydraulic hoses for the kit at the rear of the machine, unbind the unconnected end of the hoses, and remove the end plugs or caps. 1 2 Note: Each hose end is labelled as to which fitting it connects. 3 9. Attach the hydraulic hoses to the fittings on the solenoid valve as shown in Figure 4. 4 g032006 Figure 2 1.
PAGE 3
Figure 5 1. Solenoid (S1) 3. Connector on the wire harness for the connectors on S1 (2) 2. Solenoid (S2) 4. Connector on the wire harness for the connectors on S2 (2) 12. Start the machine and check for hydraulic-fluid leaks around the solenoid valve and fittings.
PAGE 4