32” WHIRLWIND S.P. (ROPE STARTER, Lock e Differential, LESS Front whets MODEL NO, 26123 & MODEL NO. 25123~40001 8: up ROPE STARTER, REGULAR, LESS FRONT WHEELS MODEL NO. 26133 & MODEL NO.
To The TOR Owner This Owner Manual has been especially prepared for your information and guidance in the operation and care of your new Orc 32-inch Whirlwind 8P, Properly adjusted, operated and maintained, this | Toto Whirlwind will respond quickly and easily to emery reasonable demand and give years of reliable service. The Toto Whirlwind is manufactured by an organization of mowing machinery specialists for over 40 years. Each unit is carefully inspected and tested before leaving the factory.
N SPECIFICATION ENGINE: Brig?g’s & Castration 23AB rope start FUEL TANK CAPACITY: 8 quarts ’ CUTTER BAR CLUTCH: Tight-slack flat belt TRACTION CLUTCH: Rockford disc type on speed reducer output shaft, CUTTER BAR DRIVE: wide flat belt on 0.D. and-174" 0.D, pulleys.REDUCTION: Engine to cutter bar: 1.26:1 CUTTER BAR: arm with hardened biased riveted to ends; 32" long assembled, TRACTION DRIVE: "A" section V-belt P. Dor 4.9 P.D. engine pulley to 6.3 P.D,, 5.3 P.D. or 4.3 P.D.
OPERATING FIG. A. HEIGHT OF CUT ADJUSTMENT T'6 change height of cut, insert spanner wrench A" in position on cutter shaft pulley, Then place wrench "H" on large net and turn in direction as shown. After nut is loose, threaded shaft "D can be turned down for low cut or up for high cut as desired. Holes "C" in shaft are spaced in 1/2" increments. No adjustments are necessary under housing. FIG. B.
TRANSMISSION ASSEMBLY Drawing No, 251-5 Ref. No. Regret. No. No. | Part No. Description. Used No.| Part No.
MAIN FRAME ASSEMBLY PARTS LIST Ref, No. Ref. Ho. No. | Part Mo Description Tad No. | Part No.
-CONTROL LINKAGE ASSEMBLY PARTS LIST Ref. No. Ref. No. No. | Part No.
SULKY ASSEMBLY PARTS LIST Ref, No. Ref. No. No, | Part No, Description Used, No. | Part No, Description Used; 1 [2-5448 | Sulky Frame i 44 [setscrew 37040 |256-85 | Bushing TOE KRAFT e g 3 [3-1332 | Washer 1 48 13292 | Screw 2 4 |3-2121 | cork 1 47 |3-1184 | Sat 1 5 14-1540 Fender 1 48 [3-2715 | Sheave, Rear Cable 1 6 [3214-18 | Axle Root 1 49 [3206-20 | Lockout 2 7 |242-4 | Retainer 2 50 [351-3 | Seat 1 8 [242-11 | Hub Only 1 51 |3233-9 |Bolt b{\( 1 9 [252-48 | Wheel Bearing 2 52 |4~0340 | Seat Spring 1 10
DIFFERENTIAL CLUTCH ASSEMBLY PARTS LIST Ref, No. Ref. Part No. Description Used No,| Part No.] Description Used 1 |3-1195 Tire 2 ar| 3-3471 Pedal |241-13 ‘Wheel Duse, Miner 4 38 | 321-4 Caseworker 1 5 323-4 Caseworker 12 39 | 32175 Nut, Hex 1 6 |8953-5 Lock washer, Heavy 12 40 8-1443 Bracket, Return Spring 1 7 | 82177 Nut, Hex 12 41 |3-1450 | BracketR. H.
TOR PARTS LIST INSTALLATION INSTRUCTIONS and PARTS LIST for Steel Wheel Kit No. 26210 1 . Ref. No. 12 — No.| Part No. Description Used 13 1 |4-1750 | Front Wheel 7 2 |4-1780 | Wheel Housing Cap \ 3 [3-6373 | Bearing 4 |4-1210 | Spring Seat 5 14-1220 |Spring 6 |1-6329 | Wheel Housing, Left * |1-6539 | Wheel Housing, Right 7 |M-62 plug 8 |3246-2 | Set Resew 9 |4-1150 |Bushing 16 [301-11 bottler 11 |32146-5 |Stop Nut 12 |3256-24 |Washer, S.A.E.
TOR INSTALLATION INSTRUCTIONS For Wheel Caster Kit No.26220 PARTS LIST Ref. No. No. | Pat No.
'ENGINE No. 221-240 DRAWING A" SYNFUEL B Furn 2 44 BEY SASSY, UPPER o < CARBURETOR, 70 assembly FOR CARBURETOR OVERHAUL KIT ORDER PART NO. . ' Drawing No.
ENGINE No. 221-240 DRAWING A" PARTS LIST Ref, No. Ref. No, No. | Part No. Description Used No, | Part No, Description Used| 1 1 291871 | Guide, Front Air # 36 | 68477 Gasket, Filter Bowl 2 1 22907 Support, Upper Fuel Tank 37 | 68487 Bowl, Fuel Filter 3 | 22813 Bracket, Fuel Tank 38 | 99010 Filter Says, Fuel 1 4 292415 | Tank, Fuel 3% 59665 Yoke Says, Fuel Filter 5 | 69221 Cap, Fuel Tank (Screw-on) 40 | 291655 | Body Says, Upper Carib, 5§ 89961 Cap, Fuel Tank {Bayonet) 41 | 292681 | Needle Valve Says.
ENGINE No. 221-240 DRAWING PARTS LIST Ref, No. Ref. No. No. | Part No Description Used No, | Part.No. Description Used 1 295677 | Housing, Flywheel 30 80700 Cap screw 2 69932 Hope, Starter 31 281672 | Support Says, Ball Brg. 3 22809 Pulley, Rope Starter 32 290832 | Oil Seal 4 23049 Nut, Flywheel * 33 27874 Gasket, . 005" 5 82272 Cap screw 4 34 27315 Gasket, ,00$" 8 90366 Lock washer * 35 27348 Gasket, .
ENGINE DRAWING "*C’ PARTS LIST 10 | Cup, Valve Spring 11 | 65606 Spring, Valve 12 ] 68293 Retainer, Valve Spring 13 68283 Collar, Val. Spg. Ret. 14 66214 Gasket 15 | 22785 Cover, Valve . 16 | 80931 Cap screw *17 22358 Washer, Valve Cover 18 | 220851 | Clip 18 22814 Lever, Gov. Control 20 | 23848 Bushing, Control Lever 21 91422 Cap screw 22 | 90832 Lock washer 23 26764 Spring, Governor 24 | 201364 | Crank Says. 25 | 22828 ‘Waugh, Gov. Crank 26 | 51984 Cotter Pin a7 291365 Lever Says. 28 1 90358 Nut .