Service Manual

Figure 4-4
Throttle Control and Carburetor
1. Refer to “Removal-Carburetor’’ on page 12.
2. Refer to disassembly steps 5,6,7,8 on page
12-13 if further carburetor service is necessary.
Flywheel
1. Use a screwdriver through the starter cup to
2. Use a 19 mm socket to remove the flywheel
hold the flywheel in place.
nut. See Fig. 4-5.
5. Examine the condition of the flywheel taper,
keyway and crankshaft key and taper. See
Fig. 4-7.
Figure 4-7
Figure 4-5
3. After the flywheel nut is removed, unscrew
the three fasteners retaining the starter cup.
4. Mount flywheel puller#41-7650 and remove
the flywheel. Insert the screws for the puller
into the same holes used by the starter cup
retaining screws. See Fig. 4-6.
Breather
1. Remove the two screws retaining the breath-
er assembly cover. Use a 10 mm socket or
wrench. See Fig. 4-8.
Figure 4-8
2. Under the cover will be a gasket, a reed plate
and another gasket.
Figure 4-6
Figure 4-9
23