Service Manual

24 ZT-2800
®
/ZT-3100™/ZT-3400™
FAN AND PULLEY (Continued)
RefertoFigure18
Disassembly
FAN AND PULLEY KIT (207) CONFIGURATION “D”
(ZT-2800/ZT-3100)
1. Remove the locknut (122), slotted washer
(123), pulley (121), fan (120) and pulley disc
(121) the from the input shaft.
Inspection
1. Check all components for excessive wear
or damage. Replace if necessary.
2. Inspect input shaft splines for wear or dam-
age.
Assembly
1. Reassemble all parts in the reverse order
of disassembly.
2. When tightening the fasteners, refer to the
table on page 21 for the required torque
values.
NOTE: Asageneralrule,usethelowendof
the torque specication on fasteners
whenreassemblingtheunit.
Figure 18, Fan/Pulley Kit (207) Conguration “D”
122
124
121
123
120