Service Manual
36 ZT-2800
®
/ZT-3100™/ZT-3400™
Figure 33, Pump/Motor Cylinder Block Assembly
CYLINDER BLOCKS
RefertoFigure33
Inspect each component of the cylinder block
assemblies for wear or damage. Inspect the
cylinder block’s running surface for scratches
or galling. Replace if necessary.
NOTE: During separation of the cylinder
blocks, take care not to damage the
surfacesofthepistonsandblock.
Applyathincoatingofoiltoallcompo-
nentsofthecylinderblockassemblies
beforereassembly.
After reassembling the cylinder block compo-
nents, set aside until ready for installation of
the center section and swashplate. Refer to
pages 30 and 31.
Figure 32, Plug Seal (26)
RefertoFigure32
In order to gain access to the check plugs (24
& 25), it is necessary to remove the plug seals
(26). This is accomplished by inserting a seal
hook or puller into, and through, one of the
insertion points (rectangularrecesses) on the
plug seal, refer to gure 31. After successfully
removing the plug seals, discard and replace
with new seals.
CHECK PLUGS & SEALS
Pistons
Piston Seats
Cylinder Block
Springs
Insertion Area