7o Tte Ford Mourner This Owner Manual has been especially prepared for your information and guidance in the operation and care of your new Toto mower. Information on care and operation of the engine is contained in a separate manual furnished with the engine.
OPERATING INSTRUCTIONS ASSEMBLY INSTRUCTION To prepare your new. Sport Lawn for mowing, attach the lower handle section VA" to the mower frame by snapping it over the handle studs "B as shown in Figure 1, Then bolt this section to the handle stop brackets "C” with the two short bolts you will find in the plastic bag attached to the mower. Be sure handle brace "D at the upper end of this handle section "A" has the flange facing down. Then insert cotter keys in holes provided in handle studs "BY.
SERVICE INSTRUCTIONS CHAIN ADJUSTMENT The chain (Ref. 62, page 5) may be expected to Loosen at first as the high spots are worn off. To tighten insert shims AV between counter shaft housing "B"and platform nCM This is easily done by loosening the four resews D" holding the counter shaft housing to the platform. There should be a slight amount of slack in the chain when it is properly adjusted. Be sure you do not get it too tight, See Figure 3 for this adjustment.
IMPORTANT ORDERING To Insure getting correct pairs without delay, please furnish the following information: INSTRUCTIONS express. All repair parts are shipped F.O.B, factory. . . Name and address where parts are to be shipped. . Do not order by reference number; use part . Serial number of your mower as shown on the name plate. . . Part number, description and quantity of each part required. . State whether parts should be shipped by mail ér number only.
g PARTS LIST No, No. . %eot. Part No. Description Used Part No. Description Used 187|210 ! 1 [ODE-186 |Side Plate Assembly, 27 |PD-316 | Bed Knife 1 Right consisting of 27 |PD-416 | Bed Knife 1 std plate & outer 28 |PD-418 | Adjustable Bar 1 Bearing Race 1 1 29 13262-10 | Rivet, Bed Knife 8 2 UPDIKE-165 |Side Plate Assembly, 29 [3280-46 | Rivet, Bed Knife T Left consisting of 30 |8274-9 Resew, $N.
PARTS LIST No, Ret No, Part No, Description Used No. | Pat No. Description Used ingrain jailbird 221-68 | Engine, Briggs & 108 320-15 | Screw, PN F.x2ivLg |1 | 1 Castration BS 1 1091 32516 Resew, 10-24 x 3" N.C. 1 1 73 {27117 VY Belt 1 i 1101 3256-14 ashier #10. PD-318A | Shim 1 1 111 PD-17 Bracket, Handle Stop PD-325 Clutch Mounting Plate 1 112 3210-3 Resew, PD-425 Oil Drain Guard 1 113 3319-2 Nut, 5/16” N, C. Full 2 2 76 132534 Lock washer 5/16" Reg.