Operator's Manual

CheckingtheMowerDeck
Front-to-RearPitch
1.Adjustthetirepressureinthereartiresto
specications;referto,page.
2.Positiononebladefront-to-rear.MeasureatAand
Blocationsfromalevelsurfacetothecuttingedge
ofthebladetips(Figure59).
3.Themowerbladeshouldbea1/4inch(6mm)lower
infrontatAthanintherearatB.Rotatebladesand
repeatforotherblades.Ifitisnotcorrect,proceed
toChangingtheDeckFront-to-RearPitch.
Figure59
ChangingtheMowerDeck
Front-to-RearPitch
Changingthefront-to-rearpitchisdonebyadjustingthe
frontheight-of-cutposts.
1.Tochangethefront-to-rearpitch,thefront
height-of-cutpostscanbeadjusted(Figure60).
Figure60
1.CasterWheel
4.Jamnut
2.CarrierFrame
5.Balljoint
3.Frontheight-of-cutpins
2.Toraisethefrontofthedeck,loosenjamnutand
rotatethefrontpinclockwise(Figure60).
3.Tolowerthefrontofthedeck,loosenjamnutand
rotatethefrontpincounterclockwise(Figure60).
4.Positionthebladesfront-to-rear.MeasureatCand
Dlocations(Figure59)fromalevelsurfacetothe
cuttingedgeoftheblades.
5.Checktheside-to-sidelevelingofthecuttingunit.
6.Tightenthejamnuts(Figure60).
CheckingtheMowerDeck
Side-to-SideHeight
1.Adjustthereartirepressuretospecications;refer
to,page.
2.Positionthebladesside-to-side.MeasureatCand
Dlocationsfromalevelsurfacetothecuttingedge
ofbladetips(Figure61).
Figure61
44