Service Manual

LINKAGE

4-122 Floating Deck Mid-Size Service Manual

Temporary Neutral Stud Adjustment

A. Actuating tab D. Switch plate

B. 1/8” - 1/4” (3 - 6mm) E. Neutral bracket

space screw (2)

C. Safety switch

A. Speed control lever D. Medium speed position

B. Full speed position E. Control panel

C. Neutral position

9. Check the travel of the shift lever in the control panel

slot. The shift lever travel should be approximately

centered in the control panel slot (Fig. 0765).

Note: Perform the following procedure on both the

left and right side.

1. Move the left and right neutral lock latches to the

unlatched position.

2. Move the speed control lever to the neutral position

(Fig. 0766).

Fig 0765 ﬁ g. 45 G001964

Fig 0766 ﬁ g. 43 G001962

10. If needed, adjust the swivel on the speed control rod

to center the shift lever travel (Fig. 0764).

11. With the speed control lever in the neutral position,

check to make sure the safety switch is depressed

and there is 1/8” to 1/4” (3 to 6mm) space between

the actuating tab and the safety switch (Fig. 0765).

12. To adjust the switch location, loosen the two neutral

bracket screws holding the switch plate to the frame

(Fig. 0765).

13. Adjust the switch up or down to obtain 1/8 to 1/4 inch

(3 to 6 mm) space (Fig. 0765).

14. Tighten the two neutral bracket screws holding the

switch plate (Fig. 0765).