Service Manual

HYDROSTATIC DRIVE SYSTEM
6-21Floating Deck Mid-Size Service Manual
6
9. Advance the forcing screw through the hub puller.
Tighten the lug nuts down evenly until the hub pops
off the wheel motor shaft (Fig. 1008).
12. Thoroughly clean the area around the hydraulic
fi ttings to prevent debris from entering the system.
13. Mark the hoses and corresponding wheel motor
fi tting ports so the hoses are reconnected back in
their original locations (Fig. 1010).
Fig 1008 PICT-0447
Fig 1010 PICT-0451
14. Position a drain pain under the wheel motor.
15. Disconnect both hydraulic hoses from the wheel
motor (Fig. 1011).
10. Remove the hub puller from the hub.
11. Remove the key from the keyway (Fig. 1009).
Fig 1011 PICT-0453
Fig 1009 PICT-0448