Service Manual

ELECTRICAL

9-37Floating Deck Mid-Size Service Manual

3. Plug the harness into the OPC switch (Fig. 1507). 5. If needed, adjust the position of the switch. Refer

to OPC Switch Position Adjustment (P.G.) in the

following section.

6. Position the cover bracket onto the control panel

(Fig. 1509).

Fig 1507 PICT-1857

Fig 1509 PICT-1848

7. Install 2 screws securing the control panel cover

bracket to the front side of the control panel (Fig.

1510).

4. With either LH or RH OPC lever depressed inspect

space between Neutral Arm on OPC Rod and the

body of the OPC Switch. The space should be .18” ±

.06” (4.6 ± 1.5mm) (Fig. 1508).

A. .18” ± .06” (4.6 ± 1.5mm)

Fig 1510 PICT-1847

Fig 1508 PICT-1864