Installation Instructions

Installation Instructions
2
Install Rear Wheels
1. Jack up rear of traction unit and support with
jack stands.
2. Remove rear wheels from traction unit (Fig. 1).
Save mounting hardware.
3. Install new tires (13x6.50–6) onto rims
4. Install rear wheels onto traction unit with
previously removed hardware (Fig. 1). Tighten
nuts securely.
1
2
3
m–2663
Figure 1
1. Tire 13x6.50–6
2. Wheel
3. Nut
Check Tire Pressure
Check front and rear tire pressure. Set at 12-15 p.s.i.
Install H-O-C Decals
1. Locate right and left decals over existing H-O-C
decals on mower frame (Fig. 2).
2. Hold firmly in position and lift one end. Tear off
backing paper and smooth into position from
center to avoid air bubbles. Lift other side of
decal, remove backing paper and smooth from
center to avoid bubbles.
3. Repeat installation of decal on other side of
mower frame.
1
2
m–2664
3
Figure 2
1. Decal
2. Mower frame
3. Move spacer to top
Adjust H-O-C
Move spacers on front castor wheels to top (Fig. 2).
See Operator’s Manual for specification.