Addendum
FORM NO. 3321-249
Operator’s Manual
MODEL NO. 30196 – 890001 & UP
MODEL NO. 30197 – 890001 & UP
ADDENDUM
The following adjustment has been added to the unit. Keep this sheet with the Operator’s Manual for reference.
Adjust PTO Bellcrank
1. Engage PTO lever and check the clearance
between the bellcrank and the axle shaft (Fig. 1).
Space should be 1/4” (6mm).
2. If adjustment is required, remove hairpin cotter
and clevis pin from bellcrank. Rotate clevis
clockwise on rod to increase or counterclockwise
to decrease clearance (Fig. 1).
m–3860
1
2
3
4
Figure 1
1. 1/4” (6mm)
2. Hairpin cotter
3. Clevis pin
4. Clevis