Installation Instructions

FORM NO. 3322–547 Rev A

Model No. 30198

INSTALLATION

INSTRUCTIONS

SOFT SIDE BAGGER

for 32", 36" & 48" MIDSIZE MOWERS

Loose Parts

Note: Use the chart below to identify parts used for assembly.

DESCRIPTION QTY. USE

Back plate

Support

Bolt 1/4–20 x 5/8” (16 mm)

Locknut 1/4–20

Washer

Assemble back plate and support

Bag and pan

Catcher frame

Handle

Bolt 1/4–20 x 1” (25 mm)

Washer 1/4” (6 mm)

Locknut 1/4-20

Assemble bag and pan to frame

Latch

Bolt 3/8-16 x 1” (25 mm)

Locknut 3/8-16

Mount back plate to mower

PAGE 1
FORM NO. 3322–547 Rev A SOFT SIDE BAGGER for 32", 36" & 48" MID SIZE MOWERS Model No. 30198 INSTALLATION INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts used for assembly. DESCRIPTION QTY.
PAGE 2
Installation Assemble Bagger 5 4 3 1. Raise deflector and align back plate with mower discharge opening. Note: 2. Hold support in position against back plate and secure with (4) 1/4-20 x 5/8” (16 mm) bolts, washers and (4) 1/4-20 locknuts. Install bolts and washers from the front of back plate (Fig. 1). 2 3 4 6 5 m–4324 Figure 1 1. Select holes 2. Back plate 3. Support 4. Bolt 1/4-20 x 5/8” (16 mm) 5. Locknut 1/4-20 6. Washer 1 2 M–4328 Figure 2 1.
PAGE 3
Installation Assemble Bag and Frame Mount Catcher to Mower 1. 1. Tilt deflector up and slide support rod into tube at rear of mower discharge opening (Fig. 6). 2. Hold back plate against discharge opening and secure to mower with latch, 3/8-16 x 1” (25 mm) bolt and 3/8-16 locknut (Fig. 6). Slide upper curved portion of bagger frame into bag and long straight rod down toward pan. Snap “J” strips over frame rods (Fig. 4). 4 2 3 5 1 m–3906 Figure 4 1. Rod 2. “J” strip 1 2.
PAGE 4
Installation 4