Operator's Manual

ManualsBrandsToro ManualsRiding ProductsGroundsmaster 3000-D 2 Wheel Drive

FUSES (Fig. 31)

There are four fuses in the the machine’s electrical system.

They are located in compartment rear of the control panel.

PREPARATION FOR SEASONAL

STORAGE

Traction Unit

1. Thoroughly clean the traction unit, cutting units and the

engine.

2. Check the tire pressure. Inflate all tires to 103–138 kPa.

3. Check all fasteners for looseness; tighten as necessary.

4. Grease or oil all grease fittings and pivot points. Wipe

up any excess lubricant.

5. Lightly sand and use touch-up paint on painted areas

that are scratched, chipped, or rusted. Repair any dents

in the metal body.

6. Service the battery and cables as follows:

a. Remove the battery cables from the battery posts.

b. Clean the battery, posts and cable connections with

a wire brush and baking soda solution.

c. Coat the cable terminals and battery posts with

Grafo 112X skin-over grease (Toro Part No. 505-

47) or petroleum jelly to prevent corrosion.

d. Slowly recharge the battery every 60 days for 24

hours to prevent lead sulfation of the battery.

Engine

1. Drain the engine oil from the oil pan and replace the

drain plug.

2. Remove and discard the oil filter. Install a new oil fil-

ter.

3. Refill the oil pan with 4.5 l of SAE15W-40 CE motor

oil.

4. Start the engine and run at idle speed for two minutes.

Figure 31

1. Fuses

STARTER

20A

SOLENOID

PTO

20A

TRANS-

LIFT/LOWER

7.5A

CONTROL

IGNITION

10A

SWITCH

HIGH

COOLANT

TEMP

RELAY

TRANSPORT

RELAY

PTO

RELAY

SEAT

RELAY

IMPLEMENT

FLOAT

RELAY

CRUISE

RELAY

(OPTIONAL)

ENGINE

SHUTDOWN

DELAY

RELAY

START

RELAY