Addendum

FormNo.3360-286RevB

RearDischargeCompletionKit

InstallationInstructionsAddendum

Whenmountingtheoutsideapassemblytotheleft

rearcornerofthecuttingunit,usethe5/16x3/4in.lg.

hexheadbolt,ontheinsidehole,inplaceofthecarriage

bolt(Figure1).

Figure1

1.Outsideangleassembly2.5/16x3/4in.lg.hexhead

bolt

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

PAGE 1
Form No. 3360-286 Rev B Rear Discharge Completion Kit Installation Instructions Addendum When mounting the outside flap assembly to the left rear corner of the cutting unit, use the 5/16 x 3/4 in. lg. hex head bolt, on the inside hole, in place of the carriage bolt (Figure 1). Figure 1 1. Outside angle assembly © 2007—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 2. 5/16 x 3/4 in. lg. hex head bolt Register at www.Toro.com. Original Instructions (EN) Printed in the USA.