Installation Instructions

ManualsBrandsToro ManualsAttachmentsGuardian Recycler Completion Kit, Base 62in Mower for Groundsmaster 3320, 3280-D, 3400 and 7200 Traction Unit

FormNo.3388-444RevA

Guardian

Recycler

CompletionKit

Base62inor72inMowerforGroundsmaster

3320,3280-D,3400

and7200TractionUnit

ModelNo.30304

ModelNo.30306

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Youcaninstallthe62inchGuardianRecyclerCompletionKit,

Model30306,onthebasemower,Model30403and30645.

Youcaninstallthe72inchGuardianRecyclerCompletionKit,

Model30304,onthebasemower,Model30404and30646.

1.Blockupthedecksoitdoesnotaccidentallyfall.

2.Removethecoversfromthetopofthedeck.

3.Positiontheright,centerandleftrecyclerchambers

underthedeck,aligningthemountingholes,asshown

inFigure1(62inchmowershown).

g018219

Figure1

1.Rightchamber

3.Leftchamber

5.Roller

2.Centerchamber

4.Rollerbracket6.Rollerspacer

Note:UsetheChamberMountingHoleschartto

determinehowmanychambermountingholesareused

foreachdeckapplication.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3388-444*A

Summary of content (8 pages)

PAGE 1
Form No. 3388-444 Rev A Guardian® Recycler® Completion Kit Base 62in or 72in Mower for Groundsmaster® 3320, 3280-D, 3400 and 7200 Traction Unit Model No. 30304 Model No. 30306 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. You can install the 62 inch Guardian Recycler Completion Kit, Model 30306, on the base mower, Model 30403 and 30645. 1.
PAGE 2
Chamber Mounting Holes Traction Units & Mower Model Number of holes used left chamber Number of holes used center chamber Number of holes used right chamber Groundsmaster 3280/3320/3400–Model 30306 5 6 4 (5 on GM3400) Groundsmaster 3280/3320/3400–Model 30304 5 6 5 Groundsmaster 7200–Model 30306 6 5 6 Groundsmaster 7200–Model 30304 6 6 6 4. If you are installing this kit on a Groundsmaster 3400, complete the following: 1 2 3 4 g018177 Figure 2 1. Spring loaded tensioner 3.
PAGE 3
5. Secure the chambers to the deck with 5/16 x 3/4 inch carriage bolts and nuts. The nuts are to be positioned outside the deck (Figure 1). Note: Steps 5, 6, 9, and 10 pertain only to the Groundsmaster 3280/3320–Model 30306. 6. Using a torque wrench or similar tool, move the spring loaded idler pulley away from the drive belt to release the belt tension and allow the belt to be slipped off the stationary idler pulley (Figure 3). Figure 4 1. Blade bolt 2. Anti-scalp cup 3.
PAGE 4
17. Affix the appropriate identification decal to the top of the mower deck near the serial plate (Figure 5, Figure 6, Figure 7). Make sure the mounting surface is clean. • Affix this identification decal, part no. 115-4514 onto 62 inch mower decks. Figure 5 • Affix this identification decal, part no. 115-4516 onto 72 inch mower decks. Figure 6 Figure 7 1.
PAGE 5
Notes: 5
PAGE 6
Notes: 6
PAGE 7
Notes: 7
PAGE 8
Declaration of Incorporation The Toro Company, 8111 Lyndale Ave. South, Bloomington, MN, USA declares that the following unit(s) conform(s) to the directives listed, when installed in accordance with the accompanying instructions onto certain Toro models as indicated on the relevant Declarations of Conformity. Model No. Serial No.