Service Manual

Groundsmaster 7200/7210 Page 5 - 31 Electrical System
Service and Repairs
NOTE: For engine electrical component repair informa-
tion, see the Kubota Workshop Manual, Diesel Engine,
05 Series.
PTO Solenoid Valve Coil
The PTO solenoid valve coil on the transmission (Fig.
44) can be replaced without opening the hydraulic sys-
tem.
Removal
1. Park machine on a level surface, lower cutting deck
(or implement), engage parking brake, stop engine and
remove key from the ignition switch.
2. Disconnect the wire harness electrical connector
from the PTO solenoid valve coil connector.
3. Remove the nut from the spool assembly.
4. Slide the coil assembly from the solenoid valve stem
(Fig. 45).
5. Clean any corrosion or dirt from the valve stem.
Installation
1. Slide n ew coil assembly, seals and washers onto the
solenoid valve stem. Make sure to properly position
seals and washers (Fig. 45).
IMPORTANT: When securing solenoid valve coil to
solenoid, do not over- tighten hex nut.
2. Install the hex nut onto the spool assembly and
torque nut from 53 to 69 in- lb (5.9 t o 7.8 N- m).
3. Connect the wire harness electrical connector to the
solenoid valve coil connector.
1. Transmission
2. Solenoid valve and coil
3. Coil connector
Figure 44
3
1
2
1. Hex nut
2. Lock washer
3. Washer
4. Seal
5. Solenoid valve coil
Figure 45
53 to 69 in- lb
(5.9 to 7.8 N- m)
5
4
3
2
1
4
Electrical
System