Service Manual

Groundsmaster 7200/7210Page 6 – 22Chassis
Cutting Deck Lift Arms
1. Roll pin
2. Flange head screw
3. RH rear lift arm
4. Lock nut (2 used)
5. Cap screw
6. Spacer
7. Flange nut (2 used)
8. Height of cut pin
9. LH rear lift arm
10. Retaining ring (2 used)
11. RH front lift arm
12. Cap screw (4 used)
13. Link (2 used)
14. Deck lift shaft
15. Washer (2 used)
16. Jam nut (1 used per ball joint)
17. Ball joint (4 used)
18. Pivot pin
19. Lift cylinder
20. Cap screw (4 used)
21. Woodruff key (2 used)
22. Deck lift chain (4 used)
23. Flange nut (6 used)
24. Lock nut (3 used)
25. LH front lift arm
26. Washer (2 used)
27. Pull link assembly (2 used)
Figure 21
FRONT
RIGHT
21
13
9
23
25
23
22
20
12
24
18
17
15
1
16
14
19
8
7
6
5
3
11
10
2
4
26
31
50 ft–lb
(67 N–m)
22
23
50 ft–lb
(67 N–m)
20
27
Disassembly (Fig. 21)
1. Park machine on a level surface with the cutting deck
in the fully raised position. Stop engine, engage park-
ing brake and remove key from the ignition switch.
2. Note location of HOC pin in HOC bracket for assem-
bly purposes (Fig. 22). Remove HOC pin from HOC
bracket.
3. Start engine and fully lower cutting deck. Stop en-
gine and remove key from the ignition switch.
1. HOC pin 2. HOC bracket
Figure 22
1
2