Service Manual

Groundsmaster 7200/7210Page 3 -- 14Kubota Diesel Engine
Engine
Figure 9
1. Flywheel coupling
2. Cap screw (6 used)
3. Cap screw
4. Muffler bracket
5. Carriage screw (2 used)
6. Flange lock nut (2 used)
7. Flange nut (4 used)
8. Fan spacer
9. Flange head screw (4 used)
10. Cooling fan
11. Engine (GM 7200 shown)
12. Lock nut (2 used)
13. Separator bracket
14. Flange head screw (8 used)
15. Fuel hose (return)
16. Fuel hose (supply)
17. Hose clamp
18. Elbow fitting (2 used)
19. Flange head screw (3 used)
20. Fuel/water separator
21. Fuel hose
22. Lock washer
23. Negative battery cable
24. Flange nut (4 used)
25. Rear mount
26. Lock washer (9 used)
27. Cap screw (8 used)
28. Socket head screw (2 used)
29. Engine mount (2 used)
30. Snubbing washer (2 used)
31. Cap screw (2 used)
32. Lock washer
33. Exhaust gasket
34. Wire harness ground
35. Fan pulley
36. V--belt
37. Cap screw (4 used)
38. E--ring
39. Hose clamp (3 used)
40. Hose clamp
41. Throttle cable
42. Flange nut (3 used)
43. Flywheel housing
FRONT
RIGHT
50 to 60 ft--lb
(68 to 81 N--m)
19 ft--lb
(25.7 N--m)
Loctite #271
12
25
26
27
37
29
19
22
30
31
16
33
7
5
4
6
28
2
1
3
26
32
13
18
20
39
14
39
18
35
36
15
17
19
39
14
21
38
40
24
8
9
10
11
23
23
34
43
41
42
42
34 to 42 ft--lb
(47to56N--m)
14 to 19 ft--lb
(19to26N--m)
Terminal Protector
Terminal
Protector
Engine Removal (Fig. 9)
NOTE: When removing the engine using the following
procedure, the flywheel housing and transmission will
remain in the machine.
1. Parkmachineonalevelsurface, lower cutting unit
(or implement), stop engine, engage parking brake and
remove key from the ignition switch.
2. Remove hood from machine (see Hood Removal in
the Service and Repairs section of Chapter 6 -- Chas-
sis).
3. Raise and support operator seat.
4. Remove six (6) flange head screws that retain rear
panel to frame (Fig. 1 0). Remove rear panel.
5. Remove air cleaner from the engine (see Air Cleaner
Assembly Removal in this section).