Operator's Manual

If you leave the key in the ignition switch, someone

could accidentally start the engine and seriously

injure you or other bystanders.

Remove the key from the ignition switch before

you do any maintenance.

Caution

Greasing the Bearings,

Bushings and Gear Box

The machine has grease fittings that must be lubricated

regularly with No. 2 General Purpose Lithium Base Grease.

If the machine is operated under normal conditions,

lubricate all bearings and bushings after every 50 hours of

operation or immediately after every washing.

The grease fitting locations and quantities are:

• Castor fork shaft bushings (2) (Fig. 17)

• Spindle shaft bearings (3) (located under the pulley)

(Fig. 18)

• Idler arm shaft bearings (Fig. 18)

• Lift arm pivots–front (2) (Fig. 19)

• Lift arm pivots–rear (2) (Fig. 20)

Figure 17

Figure 18

Figure 19

Figure 20