Installation Instructions

1
All Rights Reserved
Printed in the USA
W 2006 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
V–Plow Mounting Kit
Groundsmaster
)
7200/7210 Series
(To be used with Polar Trac Model 30370 & V–Plow Model No. 30750)
Model No. 30378
Form No. 3356–245 Rev. A
Installation Instructions
1. Mount the R.H. side of the V–plow mount to the
V–plow with the long mounting pin, torsion spring and
(2) cotter pins (Fig. 1).
2
5
3
4
1
Figure 1
1. Stop bolt
2. V–plow mount
3. Long mounting pin
4. Torsion spring
5. Short mounting pin
Note: Position the torsion spring so the long leg hooks
onto the spring notch plate and the short leg hooks onto
the V–plow (Fig. 2).
1
2
3
Figure 2
1. Spring long leg
2. Spring notch
3. Spring short leg
2. Mount the R.H. side of the V–plow mount to the
V–plow with the short mounting pin and (2) 3/16 x
1–1/2 inch cotter pins (Fig. 1).
3. Secure the chain shackles to the V–plow mount and
the V–plow with a clevis pin and a 1/8 x 3/4 inch
cotter pin (Fig. 3).
4. Remove the stop bolt from the rear of the V–plow
(Fig. 3).
1
Figure 3
1. Chain