Installation Instructions

16
MOUNTING INSTRUCTIONS
16. Lower cab onto isolators.
17. Tighten rubber isolator mount nuts to 7/8” distance between
steel plates. Ensure equal distance on both sides for cab for
proper fit. See Bolt Hole Alignment Schematic for order of
fasteners.
18. Fasten remaining two side bolts on front bracket through hole
drilled in Step 10.
19. Tighten all fasteners to torque specifications.
20. Connect the cab three prong connector to the connector
installed earlier.
HEATER INSTALLATION
21. Drain anti-freeze from the engine before proceeding.
22. Located the thermostat sensor on the right side of the
thermostat housing, remove, and set aside. Install provided
3/8” NPT adaptor. Reinstall sensor on end of adaptor. Install
provided 3/8” NPT x 3/8” barb straight fitting into top of
adaptor. This is the pressure fitting.
Jodale • Perry