Installation Instructions

FormNo.3366-959RevB

SpeedReductionKit

Groundsmaster360Multi-PurposeMachine

ModelNo.30547

InstallationInstructions

Installation

1.Parkthemachineonalevelsurface,shuttheengine

off,settheparkingbrakeandremovethekeyfrom

theignitionswitch.

2.Removethe(2)outerscrewsandnuts(shownin

Figure1)fromtheframemember.

Figure1

1.Frame

3.Securethecylindermountingplatetotheframewith

(2)1/2x1–1/2inchangeheadscrewsandthe

previouslyremovednuts(Figure2).

Figure2

1.Cylindermountingplate

4.Securethejamnutontothehydrauliccylinderrod

untilitis9/16inch(1.42cm)fromtheendofthe

rod(

Figure3).

5.Securetheyokeontothehydrauliccylindershaft

untilitbottomsoutonthejamnutandispositioned

asshowninFigure3.

Figure3

1.Hydrauliccylinderrod

3.9/16inch(1.42cm)

2.Jamnut4.Yoke

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

PAGE 1
Form No. 3366-959 Rev B Speed Reduction Kit Groundsmaster 360 Multi-Purpose Machine Model No. 30547 Installation Instructions Installation 1. Park the machine on a level surface, shut the engine off, set the parking brake and remove the key from the ignition switch. 2. Remove the (2) outer screws and nuts (shown in Figure 1) from the frame member. Figure 2 1. Cylinder mounting plate Figure 1 1. Frame 3.
PAGE 2
Note: Make sure all the O-rings are in position and lubricated with hydraulic oil before connecting the fittings and hoses. mounting bolts and nuts allowing the channel to be moved to the side (Figure 6). 6. Mount the 45 degree fitting to the top of the hydraulic cylinder, positioning as shown in Figure 4. Figure 6 1. Mounting bolt and nut (2) 10. Connect the straight fitting end of the hydraulic hose to the 90 degree fitting on the side of the cylinder (Figure 7). Figure 4 1. Hydraulic cylinder 2.
PAGE 3
19. Check the hydraulic fluid level and replenish as required. 20. Operate the machine and check the operation of kit. If the speed must be adjusted, proceed as follows: • Remove the spring clevis pin securing the yoke to the traction linkage (Figure 10). • Loosen the jam nut on the yoke (Figure 10). Figure 8 1. Hose 2. 45 degree fitting end 14. Place a drain pan under the transmission. Figure 10 15. Remove the plug from the port on the top of the transmission (Figure 9). 1. Spring clevis pin 2.
PAGE 4