Installation Instructions

FormNo.3438-876RevA

RearDischargeCompletionKit

Base72inMowerforGroundsmaster

360Multi-PurposeMachine

ModelNo.30549

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Carriagebolt(5/16x3/4inch)

Flangenut(5/16inch)

Leftbafe

Centerbafe

Rightbafe

Rearshield1

Blade3

Anti-scalpcup3

Bladebolt3

Installthebafes.

PreparingtheMachine

NoPartsRequired

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.ShifttotheNEUTRALposition.

3.Lowerallattachments(ifequipped).

4.Engagetheparkingbrake.

5.Shutofftheengineandremovethekey.

6.Disconnectthebattery;refertoyourmachine

Operator’sManual.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3438-876*A

PAGE 1
Form No. 3438-876 Rev A Rear Discharge Completion Kit Base 72in Mower for Groundsmaster® 360 Multi-Purpose Machine Model No. 30549 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty. 1 No parts required – Prepare the machine.
PAGE 2
Installing the Baffles Parts needed for this procedure: 26 Carriage bolt (5/16 x 3/4 inch) 26 Flange nut (5/16 inch) 1 Left baffle 1 Center baffle 1 Right baffle 1 Rear shield 3 Blade 3 Anti-scalp cup 3 Blade bolt Procedure DANGER Mechanical or hydraulic jacks may fail to support the machine and cause a serious injury. • Use jack stands to support the raised machine. • Use only mechanical or hydraulic jacks to lift the machine. 1.
PAGE 3
g318353 Figure 1 1. Flange nut (5/16 inch) 4. Decal 2. Rear shield 3. Carriage bolt (5/16 x 3/4 inch) 5. Left baffle 6. Center baffle 7.
PAGE 4
5. Install the blades, anti-scalp cups, and blade bolts (Figure 2). Tighten the blade bolts to 115 to 149 N·m (85 to 110 ft-lb). Important: Ensure the curved part of the blade is pointing toward the inside of the mower deck. g004741 Figure 2 1. Blade bolt 2. Anti-scalp cup 6. Rotate the blades to ensure that there is no interference. 7. Tighten all the nuts and bolts. 8. Raise the front of the machine up, remove the jack stands, and lower the machine. 9.