Operator's Manual

54-9220

100-6582

1. Warning—cutting hazard to hands and fingers.

93-6696

1. Stored energy hazard—read the

Operator’s Manual.

99-5172

99-8401

1. Warning—read the

Operator’s Manual.

2. Tipping hazard—lower the cutting unit when driving down

slopes. For 2 wheel drive units, add a 41 kg (90 lb.) rear

weight. For 4 wheel drive units, do not add weight.

Specifications

General Specifications

Width of Cut 71-5/8 in. (1.82 m)

Height of Cut Adjustable from 1 to 4 in. (25 to 102 mm) in 1/2 inch increments

Blade Tip Speed 16,270 ft./min. @ 3250 engine RPM

Cutting Blades 3 heat-treated steel blades, each 3/16 in. (4.8 mm) thick and 24-3/4 in. (55 cm) long

Unit Drive System

PTO driven gear box transmits power through a “AA” section belts to all blade

spindles.

Castor Wheels

Front: 8 in. (203 mm) diameter pneumatic wheels with greaseable roller bearings

(inflated to 35–50 psi [241–345 kPa])

Rear: 6 in. (152 mm) diameter hard rubber wheels with greaseable roller bearings

Note: Specifications and design subject to change without notice.