Operator's Manual

orbyusingaheightofcutgaugeacrossthefullwidth
ofeachcutterheadforgreateraccuracyasshown.
1
G014429
=
Figure36
1.Indicatorrings
MK3FloatingCutterhead8
inch(20cm)
Pivotknucklexing:Securetheboltintherear
oatingslotposition
Figure37asshown.
1
G014430
Figure37
1.Rearoatingslotposition
Heightofcutadjustment:Theheightofcutis
gaugedbythepositionofthefrontandrearrollers.
Toaltertherearrollerposition,turntheadjustingnut
assemblybothendsclockwisetodecreaseheightofcut
oranti-clockwisetoincreaseheight-of-cut(Figure38).
3
2
1
G014431
4
Figure38
1.Adjustingnutassembly
3.Height-of-cut
2.Adjustingnuts4.Indicatorrings
Important:Donotattempttounlockthenut
assemblies.
Toalterthefrontrollerpositionloosenbolts.Release
andturnadjustingnutsbothendsclockwisetoincrease
theheightofcutoranti-clockwisetodecreasethe
heightofcut(
Figure39).
G014433
=
1
2 3
Figure39
1.Height-of-cut
3.Indicatorrings
2.Equal
Ensurethatallcutterheadsaresetatthesameheightof
cutbyreferringtotheindicatorringsorusetheheight
ofcutgaugeacrossthefullwidthofeachcutterheadas
shown(Figure39).
Tightennutsonbothends.
26