Service Manual

LINKAGE

4-34 Fixed Deck Mid-Size Service Manual

Control Linkage & Thumb Latch

Replacement - Pistol Grip

This procedure is the same for both the right side and

left side handle controls.

This procedure was done on a pistol grip – gear. The

same steps can be followed for a pistol grip – hydro

machine.

2. Slide the trunnion out of the idler arm (Fig. 229).

Fig 229 PICT-5569

3. Remove the hairpin cotter from the clevis pin retain-

ing the upper end of the control linkage to the drive

lever assembly (Fig. 230).

Fig 230 PICT-5571

1. Remove the e-clip from the back side of the trunnion

on the lower end of the control rod (Fig. 228).

Fig 228 PICT-5566

Removal