Service Manual

LINKAGE
4-38 Fixed Deck Mid-Size Service Manual
4
Fig 244 PICT-5602
Fig 246 PICT-7060
7. Install the trunnion on the lower end of the control
rod into the idler arm (Fig. 244).
9. Adjust the control rod so that 2.62” (6.65cm) of
thread extends past the trunnion (Fig. 246).
Fig 245 PICT-5566
Fig 243 PICT-5577
6. Install the nut onto the bolt securing the thumb latch
assembly to the handle bar (Fig. 243).
Note: When tightening the nut, do not over-tighten.
The thumb latch must move freely, but with-
out the assembly rattling.
8. Install an e-clip onto thebacke side of the trunnion to
secure the control rod to the idler arm (Fig. 245).
A
A
A
A
A. 2.62” (6.65cm)
A. Trunnion