Service Manual

LINKAGE
4-50 Fixed Deck Mid-Size Service Manual
4
Fig 293 PICT-5333
A. 1” to 1-1/4”
6. If adjustment is required, refer to “Adjusting the
Brake”, page 5-10.
7. Adjust the control rods so there is a 1” to 1 1/4” (2.54
to 3.175cm) gap between the upper control bar and
the fi xed bar with the wheel drive fully engaged (Fig.
293).
Fig 291 PICT-5324a & 5326a
Fig 292 PICT-5311
4. Using a ruler, measure the travel distance of the
pulley while releasing and engaging the control bar.
The travel distance should be approximately 3/4”
(19mm) (Fig. 291).
Note: If the pulley travel is more the 3/4” (19mm),
the brakes must be adjusted. Refer to
“Checking the Brake”, page 5-9.
5. Engage the Parking Brake (Fig. 292).
Note: The parking brake lever should swing into a
snug position against the upper handle while
pulling back on the upper control bar.
Fig 290 PICT-5314
3. Engage the control bar (Fig. 290).
A
A
A. 3/4” (19mm)
A
A