FORM NO. 3313-682 MODEL NO. 30712 MODEL NO. 30713 MODEL NO. 30714 INSTALLATION INSTRUCTIONS COUNTERBALANCE KIT {FOR 52", 62" & 72" CUTTING DECKS) SAFETY AND INSTRUCTION DECALS The following decal is installed on the spring cover in two locations. f they become damaged or illegible, replace them. The decal part number is listed below and in your parts catalog. Replacements can be ordered from your Authorized Orc A WARNING SPRING LOADED MECHANISM Distributor. . SEE OPERATOR'S MANUAL FOR DISASSEMBLY PROCEDURE.
INSTALLATION Note: The cutting deck and carrier frame must be installed on the traction unit before installing the counterbalance kit. Fully raise the cutting deck, set the parking brake, rotate the ignition key to OFF and remove it from the ignition switch, Place blocks under the cutting deck to prevent it from dropping during assembly. Note: Mounting brackets must be installed in different configurations {Fig.
Figure 6 1. Mounting bracket & Top spring end 10. Knee fink 2 Spring cover 7. Bottom sprig end 17, Shoulder bolt (21 3. Lock pin assembly (2 8. Clevis pin 72, Flatware (2} 3. Leif-tapping screw (2] 8. Coir pin cotter 13 Lockout (2} 5 Extension spring 3. Position the knee link mount hole to the rear and toward the outside of the cutter deck, Then, attach the knee link to the lower spring end with a shoulder bolt, flat washer and lockout (Fig. 7, 8). 4.
2. At each bracket, align slotted holes in the spring cover (slot toward the bottom) with the mounting bracket holes. Insert lock pin assemblies into the bracket holes and secure to the bracket with wiretapping screws {Fig. 9}. Morgue the screws to 20 ft-bi. 3. Thread the top extension spring coils into the holes in the top spring ends and the bottom extension spring coils into the holes in the bottom spring ends (Fig. 9). Figure 9 1. Adapter (21 7-0 & 220 models 10, Extension spring 2 Moon ting bracket 11.