Operator's Manual

2
1. Ensure that the standard right and left ball
joint mounts that attach to the implements and
push arm ball joints are removed.
2. Assemble the left and right Quick Attach
implement brackets onto the implement using
the same holes, hex hd cap screws and nuts
as the ball joint mounts. Note that the tapered
pins and the mounting holes on the left bracket
are set closer together and the mounting
flange orientation is perpendicular to the right
bracket.
3. Replace the clevises on the ends of the
lifting chains that connect to the lift arm with
the chain connector links.
4. Apply the Align PTO Shaft" decal (99-
6522) to the implement PTO half shaft so that
it aligns with the alignment spline on the inside
of the PTO shaft and the white mark on the
splines (see Tractor Quick Attach Adapter Kit
Installation).
NOTE: For TORO Broom installation refer to
TORO Broom manual.
1. Right Implement Bracket 2. Left Implement Bracket
1
2
INSTALLATION