Operator's Manual
# '&!,)+!'& Out front deck with a right hand
trim offset. Four individual chambers jointed for
articulation. One blade per chamber.
,++!& !+ 82".
%) ',*!& 12 GA. steel, 4.5" deep, welded
construction and reinforced with 10 GA high strength
formed plates.
! +',+ 1" to 4" by 1/4" increments.
$ !0 Four 22" long by 2.50" wide by .25" thick
heat treated steel with formed parallel sails.
$ -)$( 2" in the flat configuration.
$ )!- Hydraulic drive via a PTO driven high
efficiency gear pump on the traction unit integrated
hydrostatic transaxle (IHT). Four integrated spindle
motors operated in a series configuration through
SAE-10 (.625) high pressure wear resistant hoses
with high density polyethylene protective tubing.
Spindle motor is a high efficiency pressure balanced
gear motor with a direct drive to the spindle shaft
operating in a constant wet lubrication on two Teflon
coated journal bearings. Welded blade retainers
mounted through a tapered joint with a 2" high outer
shield to protect spindle seals. Hydraulic braking valve
set to 600 psi to achieve a complete blade stopping
time of 5 seconds from full engine (PTO) speed.
$ ( 15,724 feet per minute tip speed (2730
rpm spindle speed) at 2795 rpm on diesel models and
3275 on gas models.
,*(&*!'& *+') $* Five front castors and
three rear castors, consisting of 8" pneumatic wheels
with sealed ball bearings. One rear link suspended
from the right lift arm. Hydraulic counter balance and lift
system designed integral with deck for maximum
floatation.
&+!$( +,)* 11" diameter anti scalp cups
located .75" below each blade. Adjacent chambers
pivot freely about two independent 60_ opposed
hinges down -20_ and up +20_. 1" diameter
anti-scalp/wear skids located on each outside
chamber.
!* ) Evenly dispersed rear discharge between
the outside width of the deck with partial recycling rear
baffles.
!+)&*(')+ Stainless steel cables from outside
chambers to nearest lift arm actuated via a lever on the
lift arms. Complete deck is lifted via the traction unit lift
system.
',&+)$& Recommended operating
counter balance pressure of 125 psi set by an
adjustable counter balance valve on the traction unit.
-) &)!%: Deck is offset to the right of the
traction unit to provide overhang of 21" on the right and
8.25" on the left with deck in a flat configuration. Uncut
circle is 16 inch on right with no brakes.
'-)* No complete deck covers required. Hydraulic
hoses to be covered per ANSI/ISO standards.
'&&+!*'&&+ Use existing GM 3000 style of
quick attach lift arm system. For ease of cleaning and
maintaining oil cleanliness, the hydraulic lines use
flush face quick couplers for pressure supply line,
return line, braking sense line, and motor case drain
line.
',& -$*: Operator ear to be 90 dBA per SAE
measuring standards.
+/ Deck and traction unit to comply with ANSI
B71.4-1990 and CE compliance.
)',+!-!+/ Mows up to 4.6 acre per hour at 5.5 mph
(()' &$ Minimum approach angle (for
trailering) of 11.5 at highest HOC setting.
! + 745 lbs.
(!!+!'&* & *!& *,"+ +' & .!+ ',+ &'+!