Installation Instructions

Table Of Contents

FormNo.3390-695RevA

LightKitforHighLiftCollection

Groundsmaster

3604-WheelDriveMulti-PurposeMachine

ModelNo.30816

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

Thisproductcontainsachemicalorchemicals

knowntotheStateofCaliforniatocausecancer,

birthdefects,orreproductiveharm.

InstallingtheLightAssembly

1.Installthewiringharnesswiththeroundreceptacle

intothebulkheadassembly(Figure1)onthemachine.

Figure1

2.Routethewiringcablestotheconnectorsshownin

Figure2.

g0293 82

Figure2

1.Leftlampconnector

2.Rightlampconnector

LeftLight

RightLight

Ground

WhiteWhite

PositionlightBlackBrown

BrakelightRedRed

TurnlightYellow

Green

g029678

Figure3

1.Positionlight

3.Ground

2.Brakelight4.Turnlight

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3390-695*A

PAGE 1
Form No. 3390-695 Rev A Light Kit for High Lift Collection Groundsmaster® 360 4-Wheel Drive Multi-Purpose Machine Model No. 30816 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. 1 2 Installing the Light Assembly 1. Install the wiring harness with the round receptacle into the bulkhead assembly (Figure 1) on the machine. g0293 82 Figure 2 2.
PAGE 2
3. Disconnect the current (EU light kit harness) connectors noted in Figure 2 and plug them into the wiring harness for this kit. 4. Using the bracket as a template, drill holes into the hopper. Plug the connectors on the wiring harness for this kit into the holes (Figure 2). 5. Mount the lamps on both sides, left and right of the collection exhaust duct, using the holders on the rear shell (Figure 4). Figure 5 License Plate Light Ground White Light Black Figure 4 6.
PAGE 3
Pin Assignment for the Trailer Plug 1 Yellow 2 n/a 3 White 4 Green 5 Brown 6 Red 7 Black 15. Test the lights: turn signals, brake light, and tail light. Figure 7 Figure 8 13. Raise the hopper to ensure that the cable is not tensioned at any point. 14. Mount the trailer plug.
PAGE 4