Operator's Manual

2.Insertapunchthroughtheendoftherollerhousing
anddrivetheoppositebearingoutbyalternatingtaps
totheoppositesideofinnerbearingrace.Thereshould
bea0.060inch(1.5mm)lipofinnerraceexposed.
G01 1356
1
2
3
4
Figure17
1.Frontroller3.Bearing
2.mountingbolt4.Bearingspacer
3.Pushthesecondbearingoutinpress.
4.Inspecttherollerhousing,bearings,andbearingspacer
fordamage(Figure17).Replacedamagedcomponents
andassemble.
AssemblingtheFrontRoller
1.Presstherstbearingintotherollerhousing(Figure
17).Pressontheouterraceonlyorequallyonthe
innerandouterrace.
2.Insertthespacer(Figure17).
3.Pressthesecondbearingintotherollerhousing(Figure
17)pressingequallyontheinnerandouterraceuntil
theinnerracecomesincontactwiththespacer.
4.Installtherollerassemblyintothedeckframe.
Important:Securingtherollerassemblywitha
gaplargerthan0.060inch(1.5mm)createsaside
loadonthebearingandcanleadtopremature
bearingfailure.
5.Verifythatthereisnomorethana0.060inchgap
betweenrollerassemblyandtherollermountbrackets
ofthedeckframe.Ifthereisagapover0.060inch,
installenough5/8inchdiameterwasherstotakeup
theslop.
6.Securethemountingboltto80ft-lb(108N-m).
Storage
Ifthecuttingdeckisseparatedfromthetractionunitforany
lengthoftime,installaspindlepluginthetopofthespindle
toprotectthespindlefromdustandwater.
13