Operator's Manual

Adjusting the Blower Belt

Make sure belt is properly tensioned to ensure proper

operation of the machine and unnecessary wear. Check belt

frequently.

Note: Check/adjust the blower belt tension after the first 20

hours of operation.

1. Remove the 3 capscrews, 6 washers, and 3 nuts

securing the belt guard to the blower housing (Fig. 11).

Remove the guard.

Note: The drive shaft does not have to be disconnected to

adjust the belt.

Figure 11

1. Belt guard

2. A new belt is properly tensioned when the idler spring

body is extended to a length of 3-1/4 to 3-1/2 in.

(83–89 mm) (Fig. 12).

3-1/4 to 3-1/2 in.

(83–89 mm)

Figure 12

1. Idler spring

3. When the belt stretches, adjust it as follows:

A. Loosen the nuts securing the belt tensioner to the

blower housing.

B. Move the belt tensioner (Fig. 13) down until the

idler spring body is extended to a length of 3-1/4 to

3-1/2 in. (83–89 mm) (Fig. 12), then tighten the

nuts.

4. Install the belt guard to the blower housing with the

capscrews, washers, and nuts.

Figure 13

1. Belt tensioner 2. Belt tensioner notch