Setup Instructions

Printed in the USA

W 2006 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Groundsmaster

)

4500-D

Groundsmaster Traction Unit

Model No. 30856—Serial No. 260000001 and Up

Form No. 3356–364 Rev. B

CE Compliance Set Up Instructions

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts

Note: Use this chart as a checklist to ensure that all parts necessary for assembly have been received. Without these parts,

total setup cannot be completed. Some parts may have already been assembled at the factory.

Description

Qty. Use

Throttle stop

Set screw

Install for CE compliance

Lift latch

Latch bracket –R.H.

Latch bracket –L.H.

Flange lock nut 1/4–20

Install on control console for CE compliance

Lock bracket

Screw 1/4–20 x 1/2”

Washer .281 x .625

Lock nut 1/4–20

Install on hood latch for CE compliance

EEC decals 2 Apply to machine for CE compliance.

EEC certificate 2

Install Throttle Stop

1. Loosen set screw on throttle stop.

2. Slide throttle stop onto high idle stop screw (Fig. 1).

Slot in throttle stop to be positioned over rib on engine.

3. Start engine and allow to run for 5 to 10 minutes. The

temperature gauge needle should be in the yellow

before proceeding to next step.

4. Adjust the high idle to 2760 rpm with the cutting units

disengaged.

5. Tighten setscrew. Apply adhesive into setscrew to

prevent tampering.

Figure 1

1. Throttle stop 2. Set screw

PAGE 1
Groundsmaster) Form No. 3356–364 Rev. B 4500-D Groundsmaster Traction Unit Model No. 30856—Serial No. 260000001 and Up CE Compliance Set Up Instructions Note: Determine the left and right sides of the machine from the normal operating position. Loose Parts Note: Use this chart as a checklist to ensure that all parts necessary for assembly have been received. Without these parts, total setup cannot be completed. Some parts may have already been assembled at the factory. Description Qty.
PAGE 2
Install Cutting Unit Lift Latch Installing the Hood Latch 1. Rotate latches and remove control panel cover (Fig. 2). 1. Unhook the hood latch from the hood latch bracket (Fig. 3). 2. Slide the hood lock bracket onto the latch (Fig. 3). 3. Hook the latch onto the hood latch bracket (Fig. 3). 4. Insert a bolt (1/4 x 1-1/2 in.) through the hood lock bracket and secure it with a flat washer and locknut (Fig. 3). 1 2 3 2 1 3 5 6 Figure 3 1. Hood latch 2. Hood latch bracket 4 Figure 2 1.