Setup Instructions

Printed in the USA

W 2007 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Groundsmaster

)

4500-D and 4700–D

Groundsmaster Traction Unit

Model No. 30856—Serial No. 270000401 and Up

Model No. 30868—Serial No. 270000401 and Up

Form No. 3358–103 Rev. A

CE Compliance Set Up Instructions

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts

Note: Use this chart as a checklist to ensure that all parts necessary for assembly have been received. Without these parts,

total setup cannot be completed. Some parts may have already been assembled at the factory.

Description

Qty. Use

Lock bracket

Screw 1/4–20 x 1/2”

Washer .281 x .625

Lock nut 1/4–20

Install on hood latch for CE compliance

Lift latch

Latch bracket –R.H.

Latch bracket –L.H.

Flange lock nut 1/4–20

Install on control console for CE compliance

EEC decals 2 Apply to machine for CE compliance.

EEC certificate 2

Installing the Hood Latch

1. Unhook the hood latch from the hood latch bracket

(Fig. 1).

2. Slide the hood lock bracket onto the latch (Fig. 1).

3. Hook the latch onto the hood latch bracket (Fig. 1).

4. Insert a bolt (1/4 x 1-1/2 in.) through the hood lock

bracket and secure it with a flat washer and locknut

(Fig. 1).

Figure 1

1. Hood latch

2. Hood latch bracket

3. Hood lock bracket

PAGE 1
Groundsmaster) Form No. 3358–103 Rev. A 4500-D and 4700–D Groundsmaster Traction Unit Model No. 30856—Serial No. 270000401 and Up Model No. 30868—Serial No. 270000401 and Up CE Compliance Set Up Instructions Note: Determine the left and right sides of the machine from the normal operating position. Loose Parts Note: Use this chart as a checklist to ensure that all parts necessary for assembly have been received. Without these parts, total setup cannot be completed.
PAGE 2
Install Cutting Unit Lift Latch 1. Rotate latches and remove control panel cover (Fig. 2). 2. Under front of control panel, locate ends of capscrews securing control panel to frame (Fig. 2). 3. Insert left hand latch bracket up thru lift lever slot and onto capscrew. Loosely secure with 1/4–20 flange nut (Fig. 2). 4. Insert right hand latch bracket up thru lift lever slot and onto capscrew. Loosely secure with 1/4–20 flange nut (Fig. 2). 5.