Operator's Manual

14
Setup
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Note: Use this chart as a checklist to ensure that all parts necessary for assembly have been received. Without these parts,
total setup cannot be completed. Some parts may have already been assembled at the factory.
Description
Qty. Use
Seat belt
Capscrew 7/16–20 x 1”
Lock washer 7/16
1
2
2
Installing the seat belt
Manual tube
R-clamp
1
2
Installing the manual tube
Parts catalog
Pre-delivery inspection sheet
1
1
Operator’s manual
Engine manual
Operator Video
Registration card
2
1
1
1
Read before operating the machine.
View before operating machine
Fill out and return to Toro
Installing the Seat, Seat Belt,
and Manual Tube
The machine is shipped without the seat assembly. Deluxe
Seat Kit, Model No. 30398, and Seat Suspension Kit,
Model No. 30395, must be purchased and installed.
1. Mount the manual tube to the seat suspension with the 2
R-clamps included in loose parts.
2. Install the seat belt to each side of the seat with a bolt
and lock washer, supplied in loose parts.
Important Make sure that the seat switch is connected
to the seat switch connector on the harness.
3. Slide the seat completely forward and backward to
ensure proper operation and that seat switch wires and
connectors are not pinched or do no contact any moving
parts.
Greasing the Machine
Before the machine is operated, it must be greased to
ensure proper lubrication. Refer to Greasing the Bearings
and Bushings section in the Operator’s Manual. Failure to
properly grease the machine will result in premature failure
of critical parts.