Service Manual

Rev. A
Groundsmaster 360Hydraulic System Page 4 − 120
Steering Cylinder (Serial Number Below 314999999)
1. Front axle assembly
2. Steering cylinder spacer (2)
3. Hydraulic hose
4. O−ring (4)
5. Hydraulic fitting (4)
6. O−ring (4)
7. Hydraulic hose
8. Retaining ring (2)
9. Grease fitting (2)
10. Ball joint (2)
11. Jam nut (2)
12. Cylinder rod end (2)
13. Steering cylinder (2)
14. Cotter pin (4)
15. Slotted hex nut (2)
16. Slotted hex nut (2)
17. Rear axle assembly
18. Hydraulic hose
19. Hydraulic hose
Figure 139
2
3
6
8
9
10
11
13
1
5
7
12
14
15
16
4
14
2
6
8
9
10
11
13
5
12
14
15
16
4
14
17
18
19
REAR AXLEFRONT AXLE
FRONT
RIGHT
57 to 75 ft−lb
(78 to 101 N−m)
80 to 90 ft−lb
(109 to 122 N−m)
80 to 90 ft−lb
(109 to 122 N−m)
FRONT
RIGHT
83 to 101 ft−lb
(113 to 136 N−m)
83 to 101 ft−lb
(113 to 136 N−m)
NOTE: For additional information regarding the steer-
ing assemblies on your Groundsmaster 360 machine,
refer to Front Steering Assembly or Rear Steering As-
sembly in the Service and Repairs section of Chapter 6
− Chassis.
Removal (Fig. 139)
1. Park machine on a level surface, lower cutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
2. If front steering cylinder is to be removed from ma-
chine, remove front cover from front axle to allow access
to front steering cylinder (Fig. 140).
1. Front cover
2. Screw (2)
3. Flat washer (2)
4. Grommet (2)
5. Tinnerman nut (2)
6. Front axle
Figure 140
1
3
4
2
5
6
FRONT
RIGHT