Service Manual

Groundsmaster 360 Page 6 − 55 Chassis
Removal (Fig. 61)
1. Park machine on a level surface, lower cutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Unlatch and raise hood.
3. Remove hair pin (item 20) from frame rod to allow
hood removal.
4. Slide hood to left side of machine to free hood sup-
port from frame rods.
5. Remove hood from machine.
6. If necessary, remove hood components using Figure
61 as a guide.
7. Check condition of all seals on frame and hood. Re-
place damaged or missing seals.
IMPORTANT:If there is a significant amount of de-
bris on radiator, verify the sealing of the radiator
area.
Installation (Fig. 61)
1. Install all removed hood components using Figure
61 as a guide. If intake screen was removed from hood,
make sure that hood seal (item 5) and hood mount (item
2) are attached to hood before installing screen. Secure
screen to hood with plugs.
2. Check that no gaps exist between hood components
and hood. If necessary, seal gaps with silicone caulk.
3. Position hood to machine and slide hood support
onto frame rods.
4. Install hair pin (item 20) to retain hood.
5. Close and latch hood.
Chassis