Operator's Manual

reversethemachinesdirectiontopullanyclippings
awayfromthewheel/forkarea.
FrontCastorWheels
1.Removethetensioningcapfromthespindleshaft
(
Figure7)andslidethespindleoutofthecastor
arm.Putthe2shims(1/8inch)ontothespindle
shaftastheywereoriginallyinstalled.Theseshims
arerequiredtoachievealevelacrosstheentirewidth
ofthecuttingunits.Slidetheappropriatenumber
of1/2inchspacersontothespindleshafttogetthe
desiredheight-of-cut;thenslidethewasheronto
theshaft.
Referto
Figure8todeterminethecombinations
ofspacersforthesetting.
2.Pushthecastorspindlethroughthecastorarm.
Installtheshims(astheywereoriginallyinstalled)
andtheremainingspacersontothespindleshaft.
Installthetensioningcaptosecuretheassembly.
Note:Whenusing1inch(25mm),1-1/2inch(38
mm),oroccasionally2inch(51mm)height–of–cut,
movetheskidsandrollertothehighestholes.
RearCastorWheels
1.Removethetensioningcapfromthespindleshaft
(
Figure9).
5
G018263
Figure9
1.Tensioningcap
4.CastorWheel
2.Shims
5.Axlemountingholes
3.“C”Shapedspacers
Note:Therearcastorforkassemblydoesnotneed
toberemovedfromthecastorarmtochangethe
height-of-cut.
2.Removeoradd”C”shapedspacersatthenarrow
portionofthespindleshaft,belowthecastorarm,
togetthedesiredheight-of-cut.Makesurethatthe
shims,notthespacers,contactthetopandbottom
ofthecastorarm.
3.Installthetensioningcaptosecuretheassembly.
4.Ensurethatallfourcastorwheelsaresetatthesame
height-of-cut.
Note:Whenusing1inch(25mm),1-1/2inch(38
mm),oroccasionally2inch(51mm)height–of–cut,
movetheskidsandrollertothehighestholes.
AdjustingtheRollers
Note:Ifthecuttingunitistobeusedinthe1or1-1/2
in.(25or38mm)height-of-cutsetting,thecuttingunit
rollersmustberepositionedinthetopbracketholes.
Toadjustthefrontrollers(
Figure10).
1.Removethescrewandnutsecuringtherollershaft
tothedeckbracket.
Figure10
1.Roller
2.Rollershaft
2.Slidetheshaftoutofthelowerbracketholes,align
therollerwiththetopholes,andinstalltheshaft.
3.Installthescrewandnuttosecuretheassemblies.
Toadjusttherear(internal)rollers(Figure11)
14