Service Manual

ENGINE REMOVAL AND INSTALLATION
4 - 2 Single Stage Snowthrower Service Manual
11. If your 20” Snowthrower is equipped with an
electric starter, remove the bolts retaining the
electric starter to the engine mounting bracket
(Figure 36). Also, remove the bolt and cable
clamp retaining the wire harness to the engine.
Finally, remove the motor tie down strap.
Figure 36 0217-019
12. Remove the engine mounting bracket that
supports the engine on the starter housing side
(Figure 37 and Figure 38).
Figure 37 – 20” Model 0217-020
Figure 38 – 14” and 21” Models 0217-021
Note: On the 20” models, it will be necessary to
remove the small self-tapping screw retaining the vane
control rod to the vane control bracket and remove the
muffler mounting nuts.
13. Lastly, remove the four mounting nuts retaining
the engine to the engine mounting bracket on the
crankshaft side (Figure 39).
The engine can now be removed from the unit for
servicing.
Figure 39 0217-022