Service Manual

ELECTRIC START SYSTEM

6 - 2 Single Stage Snowthrower Service Manual

6. Disconnect the spark plug wire from the spark

plug to prevent accidental starting (Figure 134).

Figure 134 1854-37

7. Disconnect the primer hose to the primer bulb

(Figure 133).

8. Disconnect the fuel line from the fuel tank to the

carburetor. Caution: There might be a small

amount of fuel in the fuel line. Be prepared with a

shop towel to catch any remaining fuel.

Thoroughly clean up any spilled fuel.

9. Remove the upper shroud leaving the starter rope

attached and position the upper shroud out of the

working area.

10. Remove the two bolts on the starter and snip the

wire tie holding the starter in position (Figure 135).

Figure 135 1854-39

11. Remove the starter assembly, wiring, and starter

switch box.

Installation

Reverse the removal procedures. Note: Incorrect

routing of the wire harness can cause electrical shock.

Route and fasten the wire harness away from all

moving parts. The wire tie for the starter must be

tightly secured to the starter.

CCR 1000/TECUMSEH HSK 635 STARTER

REMOVAL

1. Drain the fuel from the fuel tank using a pump type

siphon. Caution: Ignition of fuel can result in

severe personal injury of death. Store fuel in an

approved fuel storage container.

2. Remove the three bolts for the chute and chute

handle (Figure 136).

Figure 136 1854-12

(A) Mounting Screws (B) Wire Tie