Service Manual

ELECTRIC START SYSTEM

6 - 4 Single Stage Snowthrower Service Manual

10. Remove the upper shroud leaving the starter rope

attached and position the upper shroud out of the

working area.

11. Remove the two screws on the starter and snip

the tie holding the starter in position (Figure 141).

Figure 141 1854-39

12. Remove the starter assembly, wiring, and starter

switch box.

Installation

Reverse the removal procedures. Note: Incorrect

routing of wire harness can cause electrical shock.

Route and fasten the wire harness away from all

moving parts. The wire tie for the starter must be

tightly secured to the starter.

20” CCR/R TEK STARTER REMOVAL

1. Drain the fuel from the fuel tank using a pump type

siphon. Caution: Ignition of fuel can result in

severe personal injury or death. Store fuel in an

authorized fuel storage container.

2. Remove the three screws holding the control

panel nameplate and let the control panel

nameplate hang by the starter rope (Figure 142).

Figure 142 1854-28

3. Remove the three mounting bolts for the chute

assembly. Note: Some models are equipped

with a manual chute system (Figure 143).

Figure 143 1854-12

4. Remove the gas cap and cover with a clean

plastic bag and rubber band to prevent debris

from entering.

5. Remove the two bolts on the upper shroud and

remove the two bolts on the chute crank rod (if

equipped). Remove the chute crank rod and the

upper shroud assembly.

(A) Screws (B) Wire Tie

(A) Screws